#DELL PERC H200 INTEGRATED RAID CARD INSTALL#
#DELL PERC H200 INTEGRATED RAID CARD FREE#

When planning this build, I had imagined that eitherДЄ: my hypervisor, VMs, and camera footage would all be stored on the same really large RAID volume, orД«: Two arrays in the hotswap bay on the same RAID controller, one for hypervisor / VMs and one for camera footage, orД¬: Hotswap array is just for camera footage, install hypervisor and VMs on SSD or array of SSDs? Use two separate RAID controllers in the same server? Or M.2 NVME SSD in PCIe?Д«ut now realizing the compatibility issues, and since I require a larger volume to store the footage than SAS is capable of, it would seem that I'll probably need to buy a NAS for my camera footage RAID and SAS drives for hypervisor RAID, unless there is some exotic solution that would make this all work without increasing the cost of the system? Is my understanding correct? And if so, should I use an array of SAS drives in my R710 hotswap bays for my hypervisor and VM installation disk, and then, say, a NAS RAID array for storage of my security camera footage? To rephrase: if the XenServer Hardware Compatibility List says both SATA and SAS are compatible with XenServer for a given RAID controller, then either type of HDD may be used for the XenServer installation volume, but if only SAS is compatible for a particular RAID controller, then XenServer must be installed on an array of only SAS drives? SAS compatibility with storage controllers in XenServer.this applies only to the disk where you install the hypervisor, correct? but XenServer would still be compatible with, for instance, reading data from an array of SATA drives on a NAS? 6x Dell (Seagate ES.2) 3TB 7.2k RPM 6Gb/s 3.5' SAS HDD - Just found these for $37ea on Amazon.***EDIT: I returned the three Western Digital Purple and Blue SATA HDDs after deciding that SAS HDD or any SSD would be preferable to SATA HDD if acquired cheaply enough.Do I possibly want to consider a different RAID controller other than these two?

#DELL PERC H200 INTEGRATED RAID CARD FREE#

might swap the H200 for an H700 RAID controller because I thought it was more powerful? and seller offered free 'upgrade', but now I'm worried about compatibility more than specs.3x WD Purple 3TBВ 3.5' SATA Surveillance HDD ($$$).3x WD 300GB 2.5' SATA HDD (old, questionable reliability, but free).Dell R710 w/ 2x Xeon 5680 CPUs, 128GB ECC RAM (16x8GB), H200 RAID Controller, 6x 3.5' hotswap bays.I'm building a homelab PoE security camera server / general virtualization server, and I have the following hardware: Am I to understand that SATA HDDs are not compatible with XenServer using Dell's H700 or H200 RAID controllers? I need to know if SATA HDDs are compatible with XenServer 7.6CR when running in RAID on an H700 or H200 controller in a Dell R710 server.ДЄccording to XenServer's Hardware Compatibility List, the H700 and H200 only support SAS, not SATA. Homelab noob here, thanks in advance for your help!

Dell perc h200 integrated raid card